![]() Now that the software is in beta state, it is available for download and testing by anyone at the link below. ![]() The result is that the more complex printed parts should all be stronger. Any part of the geometry that is thin could benefit from this new system. Remember that thin walls are not just “thin walls”. The new slicing engine detects and deals with these pathological thin wall scenarios by dynamically adjusting the material flow to nearly fill these gaps. Virtually ever FFF 3D printer has this issue, and it has basically been ignored until now. This means there will almost always be a small gap somewhere inside the print, lessening the strength of the part because the walls are not completely solid. Normally FFF 3D printers have a bit of an issue when building thin walls: the extrusion wide is not always a perfect multiple of the wall width. The big change with the new slicing engine is how it handles gaps in 3D prints. But the real deal is the completely new slicing engine.Ĭode named “Arachne”, it has been experimentally tested for quite a while, and recently hinted at being included in 5.0. They’ve also added new print profiles for Ultimaker equipment that apparently speeds printing by up to 20%. The new version improves the user interface, as is customary on new releases, and also provides support for the new M1 chip in modern Macs. But what is it that makes version 5.0 so different? It’s time to turn the table… from designing for 3D printing, to 3D printing for design.” Until now, you had to make your design work for 3D printing. We believe that even those who have looked at 3D printing before and concluded that it may not be ready for their use, today it is time for them to look again. This is the start of a true revolution in 3D printing technology. “Ultimaker Cura 5.0 represents the biggest leap forward in print quality that the software has ever seen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |